#CALLAWAY X HOT DRIVER LOFT ADJUSTMENTS HOW TO#

End the turning action when there is a click sound.

Secure the clubhead once again by turning the earlier mentioned wrench in the clockwise direction to tighten the screw.

Fix the clubhead back so all markings are in a straight line.

Choose the preferred lie angle using Neutral (N) setting or Draw (D) setting by rotating the cog that was not used for the loft adjustment.

Alternatively, you can lower it by 1° opting for the -1 mark on the top cog.

Raise the loft by 1 ° or 2° by aligning the +1 mark in the lower cog or +2 mark in the upper cog with the line marked on the driver’s hosel adapter.

Loosen the clubhead screw with some counterclockwise of the Callaway wrench until you can take the head off.

You can follow the steps given here to adjust the OptiFit hosel to the loft as well as lie angle that works best for you. Each of these cogs has four settings that you can use to set the loft and lie angle of the driver based on your preferences. This hosel has two rotatable cogs, one over the other. The Callaway X Hot driver, like all other Callaway drivers, comes fitted with an OptiFit hosel. The adjustments supported by the Callaway X Hot driver are highlighted in the table below.Ĭallaway X Hot driver OptiFit hosel settings It also helps in hitting the ball off the ground with lesser effort. The setting is ideal if you’re looking for ways to get around an obstacle or a hazard. The shots get curved towards the left for right-handed golfers. This setting produces more draws and hooks. The C setting augments the stated loft by 1° while causing the clubface to close by 1.5° simultaneously. You will have to use more effort to swing your driver well. This face angle setting makes it a challenge for you to get your ball airborne. The shots also tend to curve too much to the right for right-handed players. Opting for this setting on your driver can help you place a slice or a fade. It opens up the clubface by 2.5° at the same time. The O setting decreases the default loft by 1°. The setting also works well when you play on a non-windy day or there are no obstacles between you and the target. It is apt for hitting straight shots down a fairway. This setting is ideal for players with a good swing. The ball goes straight to where you point your driver. This makes no change to the loft or the standard face angle. The N setting represents a square or neutral face angle.

Tighten the clubhead by rotating the wrench the other way round until you hear an audible click sound.

Reseat the clubhead with its white line aligned with the above said markings.Set the N, O or C marking on the cog present on the hosel such that they are aligned with the white dash marked on the hosel.Dismantle the clubhead of the X Hot driver from the shaft.Keep rotating the wrench to the right until it becomes loose to the maximum extent possible.Insert the Callaway wrench provided with the driver into the screw you find behind the clubhead.

#CALLAWAY X HOT DRIVER LOFT ADJUSTMENTS HOW TO#

The following steps guide you on how to adjust your Callaway X Hot driver: You can also adjust the preset face angle to have an open face or closed face angle. The loft on the Callaway X Hot driver can be adjusted up to 1 ° by adjusting setting on the hosel. How do I adjust my Callaway X Hot driver? The adjustment is made on the hosel of the driver to support different options for the loft and face angle including the standard settings. Yes, the Callaway X Hot driver is adjustable.

Callaway x hot driver loft adjustments